Split-Flap Display (6 Modules, Chainlink v2) 조립하기

Six laser-cut split-flap characters, each spun by a 12 V stepper and homed by a hall sensor, run from one ESP32 · 부품 9개 · 11단계 · Scott Bezek and the splitflap contributors 작성

Order the parts
Prepare the sensor boards
Build the Chainlink Driver and Buddy
Connect the Driver to the Buddy (no motors yet)
Glue the flap drum
Mount the motor and sensor
Fit the magnet and the drum
Close the enclosure and load the flaps
Flash the firmware
Connect motors, sensors and power
Home and calibrate

텍스트는 CC BY-SA 4.0 라이선스 · 사진과 인용의 권리는 소유자에게 있음