Monta Split-Flap Display (6 Modules, Chainlink v2)

Six laser-cut split-flap characters, each spun by a 12 V stepper and homed by a hall sensor, run from one ESP32 · 9 piezas · 11 pasos · Por Scott Bezek and the splitflap contributors

Order the parts
Prepare the sensor boards
Build the Chainlink Driver and Buddy
Connect the Driver to the Buddy (no motors yet)
Glue the flap drum
Mount the motor and sensor
Fit the magnet and the drum
Close the enclosure and load the flaps
Flash the firmware
Connect motors, sensors and power
Home and calibrate