OpenFlexure Microscope v7, Low-Cost Motorised Version

A 3D-printed flexure microscope with a Raspberry Pi camera, motorised stage and focus · 부품 12개 · 11단계 · Richard Bowman, Julian Stirling and the OpenFlexure community 작성

Set up and test your printer
Print and clean up the parts
Prepare the main body and the stand
Assemble the three actuators
Build the optics module
Mount the optics and the microscope
Assemble and mount the illumination
Fit the motors and sample clips
Prepare the Raspberry Pi and Sangaboard
Wire up the electronics drawer
Start using the microscope

텍스트는 CC BY-SA 4.0 라이선스 · 사진과 인용의 권리는 소유자에게 있음

OpenFlexure Microscope v7, Low-Cost Motorised Version

Richard Bowman, Julian Stirling and the OpenFlexure community 작성 · 예시 빌드 · 조회 9회 · 리믹스 0개

A 3D-printed flexure microscope with a Raspberry Pi camera, motorised stage and focus

0저장리믹스링크 복사

예상 부품 비용

부품 12개 중 4개 가격 있음

난이도

어려움

부품

부품 12개 · 59개

조립 가이드 시작